[PRCo] Re: Pittsburgh B-3 truck

[Fred Schneider]

I personally never took a picture of a B3 out from under a car ... and most railfans don't care about trucks ... every picture I located of a B3 was published and I felt that what I found was adequate.  The only improvement, as I stated
earlier, would have been printing different parts of the truck as overlays such as some encyclopedias did years ago.  That way you could start with the side rails, overlay the axle and great box housings, then overlay the wheels and motors,
then the spring pots, and finally the bolster.  But the economy required in railfan books would not have permitted such a luxury, nor could I have even dreamed of a transit company that would be willing to release four mechanics to set up
such a project.   At any rate, what I've seen is what you have.

Pepa Kalousek wrote: